Chameleon finishing systems are industry leading multi-function folding and gluing systems that are made up of a series of modules followed by a delivery and equipped with a package of top drives and other manipulating accessories. This modular approach allows for maximum flexibility and a wide variety of output possibilities under multiple operating conditions.

Available in 3 working widths – 650mm, 800mm, and 920mm – the Chameleon Finishing Systems S3 module builds upon our popular S2 module to provide an even greater level of production capability and customization. With both a 1 meter and 2 meter transport section combined into a single frame - each of which utilizes a separate and distinct upper bridge and beam assembly for greater set up capabilities - this module is often paired with one of our popular M series ‘feeder‘ modules to create a fully equipped multi-function folding and gluing system, all while retaining the ability to be used on it’s own as an incredibly versatile standalone production unit if needed.

 

Standard Equipment

• Vacuum Transport Cassette & Pump Assembly
• Bearing Bed Transport System
• Bridge & Beam Accessory Mounting Assembly
• Electrically Prepared for Stand Alone Operation
• A/C Inverter Drive System

 

Additional Details

Material Specification	Minimum	Maximum
Paper Board	0.15mm (.006in)	0.6mm (.024in)
Corrugated Flute	E & F & N Flutes (With Proper Preparation)

Capability	Minimum	Maximum
Speed	18.3m/min (60ft/min)	200m/min (650ft/min)
Jogging Mode	Standard Equipped
Blank Size:
- 800mm width	76 x 102mm (3 x 4in)	780 x 760mm (30 x 30in)
- 650mm width	76 x 102mm (3 x 4in)	635 x 760mm (25 x 30in)
- 920mm width	76 x 102mm (3 x 4in)	910 x 760mm (36 x 30in)

Installation Requirements
Electrical	220v/3 phase/60hz (Other voltages available)
Compressed Air	90 psi clean and dry
Air Compressor Capacity	Up to 10 cfm